What To Do If - AEG COMPETENCE 7658 B Instruction Book

What to do if... (something goes wrong?)
... the pilot lamps do not show?
... the oven does not heat?
1 You may well have not operated all relevant switches or
2. The fuse in the fuse box has blown.
... the fuses keep blowing?
Please call an approved and qualified electrician.
Faults you
can rectify
yourself
... the oven lamp fails?
See Cleaning and care on page 32.
Replacement lamps are not covered by warranty and are
not free of charge.
... the oven cannot be switched on?
Check whether
... my time of day is flashing in the display! If yes, reset my time
of day
... the audible tone of my timer is emitting a continuous tone.
Then press the corresponding button to switch it off!
... my timer display does not show, but the pilot lamps of the
appliance still show?
... incorrect indications appear in my display?
| ... duration and end cannot be entered!
8 My timer has been wrongly operated or there has been a short
o power cut. Isolate my oven from the power supply wait 30
^ seconds and then switch on the power. Reset the time of day
5 on my electronic timer.
5 Please make sure that you are not able to rectify the fault
° yourself prior to calling a service engineer in connection
g with one of the aforementioned problems, as the cost in-
T volved will have to be passed on even during the warranty
S period.
e Therefore, follow the instructions in this booklet and any
* additional information which may accompany this appli-
a ance carefully.
o AEG electrical appliances comply with current safety reg-
" ulations. Repairs to these appliances should only be car-
| ried out by qualified AEG engineers or AEG appointed
s service agents. Repairs carried out by unauthorised per-
i
sonnel could lead to considerable damage and could pose
a a considerable safety hazard to the user.
37