Table of Contents
Advertisement
Changing plinth height
If you want to change the height, first read
through all the points below before you start.
1 Lay down the cooker gently (
ILLUSTRATION
polystyrene from the packaging
between the cooker and the floor as
protection. Think about placing a
protective layer under the rear lower
corners of the cooker to protect the
floor.
2 Unscrew the screws A (4
ILLUSTRATION
slightly if you only wish to change the
height. Pull the brackets on which the
wheels and feet are fitted. NOTE! Be
careful, there are sharp edges under
the cooker.
3 Screw in the screws again A in one of
the holes for a bench height of 850 to
920 mm (33.4" to 36.2"). The distance
between the holes varies from 7 to 14
mm (0.3 to 0.5") (
4 Lift the cooker upright and connect it
up electrically. Push the cooker back
into position and make sure that it is
absolutely level before fitting the
safety equipment.
Adjusting the level
The cooker must stand level, for example to
ensure that fat is evenly divided in the
frying-pan. Place a spirit level or a frying
pan containing water on the ceramic glass
plate when you want to check whether the
cooker is level.
If necessary, from the front of the plinth
you can adjust the cooker wheels and feet by
15 mm (0.6"). Use a screwdriver to adjust
the rear wheels and a Polygrip for the front
feet.
SEE
). Use, for example, the
SCREWS
). Pull out the inner base
SEE ILLUSTRATION A
,
SEE
).
7
Advertisement
Table of Contents
