Table of Contents
Advertisement
The blade scraper
K
EEP THE BLADE SCRAPER OUT OF
THE REACH OF CHILDREN
blade scraper with care, the blade is
extremely sharp.
Use the scraper to remove boil-over from the
ceramic glass plate. Do not use the scraper
or other sharp instruments on the silicon
edge since this implies a safety risk and can
cause damage.
THIS IS HOW TO USE THE BLADE SCRAPER
1 Pull back the guard so that the blade is
visible (
SEE ILLUSTRATION
2 Make sure that the blade is clean and
whole, otherwise it could damage the
plate. You can buy new blades at a
hardware store.
3 hold the scraper at an angle of about
45° and scrape clean. You can press
the blade hard against the plate
without damaging it.
4 Carefully wipe off any dirt from the
blade with kitchen tissue.
5 After use, press the guard forward so
that it covers the blade. Store the
scraper out of the reach of children.
REPLACING THE BLADE
1 Open the scraper by fully loosening
the screw (no screwdriver needed)
and fitting the new blade at the front
edge.
2 Assemble the scraper and tighten the
screw again.
3 Press the guard as far forward as it
will go to protect the blade.
. Use the
).
:
:
32
Advertisement
Table of Contents
