Table of Contents
Advertisement
Electrical connections
Any work required on the cooker
must be carried out by a
EXPERT
qualified people can impair the
cooker and cause injury to people
and/or damage to property.
The electrical installation is to include a
device whereby it is possible to separate all
the poles of the equipment from the power
supply, with a contact opening of at least
3 mm (0.12").
This requirement must be satisfied for
safety reasons.
The connected rating and voltage are
shown on the data-plate. There is a wiring
diagram on the back of the cooker.
Decor plinth (optional accessory)
NOTE! Take due care when fitting
the base trim to the cooker. Edges
which you do not normally come into
contact with can be sharp.
NOTE! O
NLY FITS COOKERS WITH A HEIGHT
900
(35.4").
OF
MM
Remove the protective film before fitting the
base trim.
1 Remove the drawer from the cooker
by lifting it diagonally upwards and
then pulling it all the way out.
2 Fit the base trim by pressing it firmly
onto the plinth (snap attachment, no
tools needed).
3 Replace the drawer.
QUALIFIED
. Work carried out by non-
9
Advertisement
Table of Contents
