Table of Contents
Advertisement
Changing plinth height
If you want to change height, first read
through all the points below before you start.
1 Lay down the cooker gently (
ILLUSTRATION
the Frigolite from the packing
material as protection between the
floor and the cooker. Remember to
place a protective layer under the rear
lower corners of the cooker sides to
protect the floor.
2 Unscrew the screws A (4
ILLUSTRATION
plinth slightly if you only want to
change its height. Pull the brackets on
which the wheels and feet are fitted.
N
! Be careful, there are sharp
OTE
edges under the cooker.
3 Screw in the screws again A in one of
the holes for a bench height of 850 to
920 mm (33.4" to 36.2"). The
distance between the holes varies
between 7 and 14 mm (0.3 and 0.5").
(
SEE ILLUSTRATION A
4 Lift the cooker upright and connect it
up electrically. Push the cooker into
position and adjust the level before
fitting the safety equipment.
Adjusting the level
The cooker must stand level, for example to
ensure that fat is evenly divided in the
frying-pan. Place a spirit level or a frying-
pan containing water on the ceramic glass
plate when checking that the cooker is level.
If necessary, from the front of the plinth
you can adjust the cooker wheels and feet by
15 mm (0.6"). Use a screwdriver to adjust
the rear wheels and a polygrip for the front
feet.
SEE
). Use material such as
SCREWS
). Pull out the inner
).
,
SEE
7
Advertisement
Table of Contents
