Table of Contents
Advertisement
Platform Setup
2.1.1
Connect SATA cables
1. There are six SATA (Serial ATA
cables to the appropriate drive sequentially starting from connector Port SATA 0
through connector Port SATA 5. These connectors are located in coordinate E4.
P
Figure 15.
SATA Ports
Note:
Intel recommends that your boot drive be connected to SATA Port 0.
2.1.2
Plugging In Memory
Note:
Refer to section
DIMM location while reading below steps.
1. Beginning with DIMM 3, (the DIMM connector closest to the edge of the CRB,
furthest from Intel
that the end clips are moved outward to the open position.
2. Gently push the DIMM into the socket until you hear or feel the side clips lock into
the side of the DIMMs.
Note:
Continue adding memory to the system sequentially starting from DIMM 3 to DIMM 2.
June 2007
Order Number: 316639-002
Figure
Section 1.3
for memory specific information refer to
®
3100 Chipset) line up the DIMM with the slot and make sure
15) connectors on the CRB. Connect the
Figure 16
for
User's Manual
27
Advertisement
Table of Contents
Need help?
Do you have a question about the Intel CoreTM 2 Duo Processor and is the answer not in the manual?
Questions and answers