Table of Contents
Advertisement
18 electrolux
You can select two different levels of pyrolytic
cleaning depending on how dirty the oven is.
If the oven cavity is not very dirty, we recom-
mend that you select the pyrolytic 1 function
(P I) in the programmer display.
It is advisable to wipe the oven over with a
soft sponge soaked in warm water after each
pyrolytic cleaning cycle is carried out.
If the oven cavity is very dirty, we advise you
to select the pyrolytic 2 function (P 2) in the
programmer display.
During the pyrolytic cleaning function, it is not
possible to use the oven for 2 hours when
selecting the Pyr 1 function and up to 2 1/2
hours when the Pyr 2 function is active.
The Pyro reminder recommends that a
pyrolytic cleaning function should be
carried out after several baking and
roasting processes and depending on
dirty the oven is.
An acoustic signal will be heard and the
indication Pyro is displayed for approx.
15 seconds and then a second acoustic
signal can be heard.
Depending on how dirty the oven is, se-
lect the most suitable pyrolytic cleaning
function.
For as long as no complete cleaning
function is carried out, Pyro reminders
are displayed each time the oven is
switched off.
How to use the pyrolytic cleaning
function
Warning! Before activating the
pyrolytic cleaning function, remove
any excessive spillage and make
sure that the oven is empty. Do not
leave anything inside it (e.g. pans,
grids, baking tray, drip pan, etc.) as
they could become severely
damaged.
Warning! Ensure that the oven door
is closed before activating the
pyrolytic cleaning function.
Warning! When the pyrolytic
cleaning function is on, it is
advisable not to use the hob as this
could cause overheating and
damage the appliance.
Warning! During the pyrolytic
cleaning cycle the oven door
becomes very hot. Children should
be kept away until it has cooled.
Choose this function to clean the oven by
pyrolysis.
The following pyro levels are available:
Pyrolytic 1 (P I), Time: 2 hours. = 30 mins
Heating-up +1 hour. at 480 °C + 30 mins
Cooling down time.
Pyrolytic 2 (P 2), Time: 2 hours. 30 mins. =
30 mins Heating-up +1 hour. 30 mins. at 480
°C + 30 mins Cooling down time.
The pyro duration time cannot be changed.
Before performing the pyrolysis, all side
rails must have been removed.
To activate the pyrolytic cleaning
function proceed as follows:
1. Touch control
Touch the control
Pyro function symbol
appears on the display.
The symbol
will flash on the display at the same time
and an acoustic signal will sound.
This means that, before activating the py-
rolytic cleaning function, you have to re-
move all the oven accessories and the
side rails from the oven cavity.
2. The "Cooking time" symbol
for 5 seconds; during this time, touch
'
' or '
' control to select the pyro-
lytic 1 (P I) or pyrolytic 2 (P 2) function
to switch on the oven.
repeatedly, until the
(level 1 - P I)
and the indicator Pyro
will flash
Advertisement
Table of Contents
