Electrolux EKC60110 User Manual page 6

power to the cooker and contact your
local Service Force Centre.
Never lay aluminium foil, plastic
material or similar on the ceramic glass
plate. If one of the heating zones is
switched on by mistake, the material on it
can burn or melt.
Never leave a deep fat fryer, melting
fat, paraffin or other easily ignited
material without supervision. In the event
of fire, turn off the cooker knobs and
switch off the extractor fan.
THE FIRE WITH A POT LID
Never stand on the ceramic glass plate.
Check that the cooker is properly
turned off when it is not in use, with all
the knobs set at zero.
Warning! Alcohol and similar
substances that can produce explosive gases
or other substances that can cause fires or
explosions must not be used in the oven.
The ceramic glass plate must be used
with the greatest care. For example,
flaming with brandy or other forms of
alcohol can result in traces of fat in the
extractor fan igniting and causing serious
fires. In the same way, flames and
burning fat can cause injuries.
Do not place chemicals or cleaning
agents in the storage compartment.
Cleaning
Keep the ceramic glass plate and the oven
clean. Grease and spilled material can
cause a great deal of smoke when heated
and, in the worse case, imply a risk of fire.
While the oven is still hot, you must use
the scraper blade immediately to remove
sugar, and boiled-over material with a high
sugar content, for example marmelade, as
well as melted plastic and foil, to avoid
damaging the ceramic glass plate. Be
careful, the blade is extremely sharp.
EXTINGUISH
, never use water.
Maintenance and service
Turn all the knobs to zero before
replacing a burned-out oven lamp bulb.
Make sure that the cooker is thoroughly
switched off before replacing the bulb.
Pull out the plug for cookers fitted with
one. For other cookers, switch off the
power by using the multi-pole switch.
Service and repairs should be carried
out by a company that is approved by the
supplier. Use only genuine replacement
parts.
Disposal and recycling
The symbol
packing material indicates that the
product may not be treated as household
refuse. Instead it must be taken to a
disposal station for recycling of the
electrical and electronic components.
By ensuring that the product is
handled in the right way, you are making
a contribution towards preventing
possible negative environmental and
health effects which can occur if the
product is disposed of as normal refuse.
For more detailed information about
recycling, contact your local authorities
or refuse collectors or the store where you
purchased the product.
5
on the product or the