Adjustment Of Feet - Electrolux EKE56403X Operating And Installation Instructions

2. INSTALLATION AND PREPARATIONS FOR USE
• Any wrong electric connection may damage your appliance, as well as endangering your safety
rendering your guarantee invalid.
• The manufacturer declares that it has no responsibility against any kind of damages and losses
that are caused by improper connections that are performed by unauthorized person.
• The appliance is adjusted as appropriate for 230V or 220-240V and 400V 3N or 380-415V 3N of
electricity. If th network electricity is different than this informed value, immediately contact to
our authorized service.
• Use the H05VV, H05V2V2 or H05RR type supply cord.
• Some appliances can be equipped with special plug(Perilex or Norplug). If it is necessary, change
it with the same specified spare parts.
These plugs can be used only in some countries.
Use 16A/400V 5 pin for perilex plug and 25A/250V for Norplug.
• Connection diagram is given below.
• WARNING: For single phase connection, three shortcut circuit bridge must be installed as seen
above picture.
If circuit bridge is not installed properly, some of cooking zones does not operate.

3.3 Adjustment of feet

2
2
2
Your product
placed where to be used, check if the product is balanced. If it
is not balanced, you can make the adjustment by turning the
feet clockwise if required. It is possible to raise the appliance
maximum 30mm by the feet. If the feet are adjusted
appropriately, it is required not to move the appliance by
dragging, it should be moved by lifting it up
Figure 3
2
2
2
Figure 2
stands on 4 adjustable feet. When the
11
product is
.