Danfoss DHP-AX User Manual page 26

5.1.4 Sub-menu TEMPERATURE
In the TEMPERATURE menu you are able to view the
various temperatures that the installation has had.
All temperatures are stored 60 minutes (factory set-
ting) back in time so that they can also be displayed
in the form of graphs.
Menu text
OUTD
ROOM
SUPPLY LINE
RETURN LINE
HOT WATER
INTEGRAL
REFR 1
DHP-AX – 26
Description
Shows the actual outdoor temperature.
If ROOM shows 20°C the heat curve is
unaffected. If ROOM shows higher or
lower, this indicates that the heat curve
has been adjusted up or down to change
the indoor temperature.
Shows the actual supply temperature.
(The desired value is shown between
brackets.)
Read section "3 Regulation information"
for more information.
(In operating mode AUX. HEATER the
stop temperature for hot water produc-
tion is shown in brackets, increased by
5°.)
Shows the read return temperature. (The
highest permitted temperature is shown
between brackets.)
Shows the actual hot water temperature.
Heat production is controlled by a cal-
culated demand that is automatically
calculated when the installation is in
operation. The calculated value for inte-
gral displays the heating system's actual
energy balance.
Read section "3 Regulation information"
for more information.
Shows the actual temperature of the
refrigerant.
VUBMI102
TEMPERATURE
OUTD
ROOM
SUPPLY LINE
RETURN LINE
HOT WATER
INTEGRAL
REFR 1
Adjusted by:
By the customer, if
necessary.
Not adjustable
(The computer calcula-
tes the temperature
required to maintain
the indoor tempera-
ture.)
Authorized installer.
Adjusted for each instal-
lation.
Not adjustable
Not adjustable
Not adjustable
0°C
20°C
38(40)°C
34(48)°C
52°C
-660
-7°C