Powering On The Handset; Attaching The Belt Clip; Spare Battery Placement - NEC ML440 User Manual

Figure 2-4 Spare Battery Placement
NOTE
ML440 End User Guide - Revision 1
Connect the charger AC adapter to the charger's AC jack.
Step 5
Plug the other end of the adapter into a standard 120V AC power outlet.
Step 6
Place the handset in the charger with the display facing forward. The
Step 7
display on the handset should light up and the charger LED should turn
on. If it doesn't, reseat the handset or try plugging the AC adapter into a
different outlet.
Place the spare battery in the back section of the charger. (Pull the
Step 8
battery latch back to insert the battery
Charge each battery completely (approximately 10 hours) before use.

Powering on the Handset

To power up the handset, press and release the End key. (To power
down the handset, press and hold the End key.)

Attaching the Belt Clip

Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the
tabs from the holes.
Getting Started
(Figure 2-4).
2-3