Resetting Handsets; Compliance Information; Fcc Part 15 Information - NEC ML440 User Manual

4-4 Important Information

Compliance Information

If the static is on 1 handset or in 1
location
There is always more noise at the edges of the
base's range. If the handset displays Searching,
try moving closer to the base.

Resetting Handsets

You can reset all the handset options back to the default values; any
customized settings (language, ring tones, volume, etc.), will be lost.
(Resetting a handset will not deregister the handset from its base.)
Follow the steps below to reset the handset.
On the handset, press Menu.
Step 1
From the main menu screen, select the Settings icon.
Step 2
On the Settings screen, select Reset settings.
Step 3
When the handset asks you to confirm, press
Step 4
press or
When the handset asks you to enter the PIN, enter the 4-digit code used
Step 5
to access this handset. (Default 0000)
The handset reboots and restores all user settings to their default value.
Step 6

FCC Part 15 Information

Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules,
which establishes limits to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates and can radiate radio frequency energy; if not installed and
used in accordance with the instructions, it may cause harmful
interference to radio communications. However, even in proper
installations, there is no guarantee that interference will not occur. If
you suspect this equipment is causing harmful interference to a radio or
television receiver, try to correct the interference through the following
steps:
Turn the equipment off and on to confirm interference.
Step 1
Increase the separation between this equipment and the receiver.
Step 2
Connect this equipment to an outlet on a different circuit from that to
Step 3
which the receiver is connected.
If the static is on all handsets or in all
to cancel.
ML440 End User Guide - Revision 1
locations
to continue the reset;