Wall Installation - NEC 910i Installation And User Manual

Installation

Wall Installation

Standard Wall Plate Mounting
This Phone is designed to be mounted on a standard AT&T or GTE wall plate. To attach
the wall mount stand to the Base Unit:
1. Slide the Wall Mount stand into the notches at the top of the Base Unit, push the
Wall Mount stand down and snap it into place.
2. Plug the AC Adapter into the Base Unit as previously described.
3. Place the AC Adapter cord inside the molded channel of the Wall Mount stand.
4. Plug one end of the short telephone cord into the LINE jack on the Base Unit.
Optionally, plug one end of an NEC keyset desk phone into the phone jack. Then
place the telephone cord(s) inside the molded channel(s) on the bottom of the Wall
Mount stand
5. Plug the other end of the short telephone cord into the modular wall jack.
6. Place the Base Unit on the posts of the wall plate and push down until it's firmly seated.
7. Plug the AC Adapter into a standard 120V AC wall outlet.
Note: Do not use an outlet controlled by a wall switch.
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your phone directly on a wall.
Before mounting your phone, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the wall.
• Make sure the wall material is capable of supporting the weight of the Base Unit.
• Use #10 screws with anchoring devices suitable for the wall material where the Base Unit will be placed.
1. Insert two mounting screws into the wall 3-15/16 inchesapart. Allow about 3/16 of an inch between the
wall and screw heads for mounting the phone.
2. Plug and secure the AC Adapter cord by following steps 2 and 3 of theStandard Wall Plate Mounting.
3. Plug one end of the telephone line cord intothe LINE jack on the Base Unit.
Optionally, plug one end of a standard 2500 type desk phone into the PHONE
jack. Then place the telephone cord(s) inside the molded channel(s) on the bottom
of the Wall Mount stand.
4. Place the Base Unit on the posts of the wall screws and push down until it is
firmly seated.
5. Plug the other end of the short telephone cord into a telephone wall jack.
6. Plug the AC Adapter into a standard 120V AC wall outlet by following step 7 of the Standard
1-8
Wall Plate Mounting.
.