IMPORTANT: Remove all
protective plastic film from
stailess steel parts prior to
assebly/use. This film is
installed at the factory to
prevent damage that could
occur during shipment and
handling.
IGNITOR ATTACHMENT
1. Remove the ignitor cap, spring
assembly, battery and lock nut from
ignitor. (See Fig. 1)
2. Insert the threaded section of the
ignitor into the U-shaped cut out of
the ignitor mounting bracket.
(See Fig. 2)
3. Insert the threaded section of the
ignitor through the hole in the shelf
and secure to shelf using the lock
nut. (Use the ignitor assembly
diagrams to determine which
ignitor goes with which shelf
depending on grill model.) Tighten
Securely. (See Fig. 3)
4. Re-insert the battery, positive side
first, and spring assembly and
attach the ignitor cap. (See Fig. 4)
5. Repeat above steps for second
ignitor on the Side Burner.
Grill Assembly
Cap
6
Battery
Spring
Locking
Nut
Cylinder
Fig. 1
Mounting
Bracket
Fig. 2
Fig. 3
Fig. 4