General Safety; Transport, Handling And Storage; Installation And Assembly - Electrolux SPEEDELIGHT Installation And Operating Manual

Clarifications and explanations
A.3

General safety

• The machines are provided with electric and/or mechanical safety devices for protecting
workers and the machine itself.
• Never operate the machine, removing, modifying or tampering with the guards,
protection or safety devices.
• Do not make any modifications to the parts supplied with the appliance.
• Several illustrations in the manual show the machine, or parts of it, without guards or
with guards removed. This is purely for explanatory purposes. Do not use the machine
without the guards or with the protection devices deactivated.
• Do not remove, tamper with or make illegible the safety, danger and instruction signs
and labels on the machine.
• Place emergency telephone numbers in a visible position.
• The A-weighted emission sound pressure level does not exceed 70 dB(A).
• Turn the appliance off in case of fault or poor operation.
• Do not use products (even if diluted) containing chlorine (sodium hypochlorite,
hydrochloric or muriatic acid, etc.) to clean the appliance or the floor under it.
• Do not use metal tools to clean steel parts (wire brushes or Scotch Brite type scouring
pads).
• Do not allow oil or grease to come into contact with plastic parts. Do not allow dirt, fat,
food or other residuals to form deposits on the appliance.
• Do not spray water or use water jets or steam cleaner.
• Do not store or use gasoline or other flammable vapours, liquids or items in the vicinity of
this or any other appliance.
• Do not spray aerosols in the vicinity of this appliance while it is in operation.
• Do not place flammable liquids (e.g. spirits) inside the oven during operation.
• Install the appliance under conditions of adequate ventilation in order to provide a
suitable air change per hour. Make sure that the ventilation system, whatever it is,
always remains operational and efficient for the entire period of time during which the
equipment is operating.
A.4

Transport, handling and storage

• Do not stand under suspended loads during loading/ unloading operations.
Unauthorized personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts such as: casings,
electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over.
A.5

Installation and assembly

• Appliance positioning, installation and disassembly must be carried out by a specialised
technician.
• The machine is not suitable for installation outdoors and/or in places exposed to
atmospheric agents (rain, direct sunlight, etc.).
• The above operations must be carried out by the specialised technician in conformity
with the current safety regulations, regarding the equipment used and the operating
procedures.
• The plug must be accessible after positioning the appliance in the place of installation.
8