Download  Print this page

Grill Assembly/Built-In Instructions - Electrolux 44” Stainless Steel User & Care Manual

44” stainless steel gas grill
Hide thumbs

Advertisement

5
Grill Assembly
IMPORTANT: Remove all protective plastic
film from stainless steel parts prior to
assembly/use. This film is installed at the
factory to prevent damage that could
occur during shipment and handling.
SIDE SHELF ATTACHMENT
1. Loosen the bolts on the side of the grill and attach
the shelf by allowing the bolt heads to fall through
the large opening in the bottom of the keyhole
slots. Then slide the shelves downward until the
bolts are resting against the top of the key hole
slots. Tighten all of the shelf bolts. (See Fig. 1-2)
2. Attach the four (4) wires coming out from the left
side of the grill to the igniter terminals. (See Fig. 3)
Note: It does not matter which wire goes to which
terminal on the electronic igniter
INTERIOR PARTS INSTALLATION
1. Install the bottom flavor grids in the lower cutouts
and around the igniters. (See Fig. 4)
2. Insert the top row of flavor grids with the 90
degree angled heat shield (bottom side of flavor
grid) facing the rear of the unit into cutouts with tri-
angle ridges facing up. (See Fig. 5-6)
3. Install cooking grates on the ledges provided on the
grill to create your cooking surface. (See. Fig. 7)
4. Place warming shelf on support brackets by set-
ting it flat across brackets allowing the two holes
to line up with the holes on each bracket.
(See Fig. 7)
Faces the back of
the grill
Warming Shelf
Fig. 6
Fig. 7
Cooking Grates
Bottom flavor grids
in between burners
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux 44” Stainless Steel

This manual is also suitable for:

E44