Replacing The Dry Ink/Toner Waste Bottle - Xerox Versant 280 Press Quick Start Manual

Maintenance
R R e e p p l l a a c c i i n n g g t t h h e e D D r r y y I I n n k k / / T T o o n n e e r r W W a a s s t t e e B B o o t t t t l l e e
The Dry Ink/Toner Waste Bottle collects dry ink/toner that accumulates during the printing process.
When the bottle is full, a message displays on the press UI informing you to exchange the full bottle
with an empty one.
The press contains one waste bottle located at the front of the press behind the Dry Ink/Toner Waste
Bottle Door. When removing a full Dry Ink/Toner Waste bottle, SLOWLY pull it out of the press. This
will prevent any dry ink/toner from spilling out of the bottle.
Note: After you replace the Dry Ink/Toner Waste Bottle, the system automatically resets the
usage counter to zero (0) for this CRU component. Check the Consumables Supply screen to
verify the reset.
1. Ensure that the press is stopped (not running any jobs).
2. Open the front door of the press.
3. Open the Dry Ink/Toner Waste Bottle Door.
4. Grasp the handle of the Dry Ink/Toner Waste bottle and pull it halfway out of the press.
5. Support the underside of the bottle with your other hand and continue pulling it out from the
press.
Caution: Never use a vacuum cleaner when cleaning up spilled dry ink/toner. Use a broom
or a cloth moistened with a neutral detergent.
6. Use both hands to place the old used Dry Ink/Toner Waste Bottle into the provided plastic bag.
7. Remove a new, empty waste bottle from the packaging.
8. Hold the center part on the top of a new bottle and insert it evenly and gently into the press until
it comes to a stop.
9. Close the waste bottle door.
10. Close the press front door.
28 Xerox ® Versant
Quick Start Guide
® 280 Press