Omron V680 Series User Manual page 45

Power Supply Connector
Use the enclosed connector. The user must provide the cable.
Cable Power line
Connector
Crimp When one line is
Terminal connected to one
terminal
When two lines are
connected to one
terminal
Crimping Tool
1.
Attach the crimp terminals to the sections of the cable where the
sheath has been stripped.
2.
Make sure the connector is facing the right direction and insert
each crimp terminal into the correct connector hole.
3.
Once all of the cables have been connected to the connector,
attach the connector to the ID Slave.
Align the cable connector with the connector on the ID Slave. Hold the connector
body and push the connector firmly into place.
Removing the Connector
Remove the connector by pressing in on the lock on the cable connector to release the lock and pulling the connector
straight out. If the connector is difficult to remove, press on the ID Slave while pulling on the connector.
Do not connect cables to the connector after attaching the connector to the ID Slave.
Use the recommended Power Supply (S8VS-03024, OMRON).
Installation, Connections, and Wiring
Brand Model
---
FKC2.5/3-ST-5.08-RF
AI1-10RD
Phoenix Contact
AI-TWIN2 × 1-10RD
CRIMPFOX UD6
Note
--- 1.0 mm 2 (equivalent to AWG18)
---
---
---
---
RFID System
Section 4
43
User's Manual