Omron V680 Series User Manual page 31

Options
The following functions can be used with the ID Slave by setting the control signal options.
Using 4-byte (4CH), 26-byte (16CH), and 58-byte (32CH)Access Modes
Function
Communications Speed
Verification
Write Protection
Output Time
Host Communications Mode
Read/Write Data Code
Using V600-compatible Trigger(SYNC) Modes (SYNC1 and SYNC2)
Function
Output Time
Host Communications Mode
Using V600-compatible Auto Modes (AUTO1 and AUTO2)
Function
Output Time
Host Communications Mode
For the each mode and mode switch setting, refer to Mode Switch in Section 2.
p.17
The communications time required for writing large amounts of data to the ID Tag using
the DATA FILL command can be reduced by setting the communications speed to high.
Be aware that the noise resistance may be lower during communications when this
function is being used.
For details on the communications time, refer to Communications Time (Reference) .
p.118
Select whether to enable or disable the verification function.
Important data stored in the memory of an ID Tag, such as the product model or type, can
be protected from being overwritten inadvertently by enabling the Write Protection
function.
Refer to Write Protection for details.
p.32
When Auto Mode is being used, the result output time can be set to either 100 ms or
500 ms.
Refer to I/O Settings and Control Methods for details on the output timing.
p.69
Trigger Mode or Auto Mode can be selected as the method for the communications with
the PLC.
The number of bytes that can be accessed can be increased by converting the read/write
data code from ASCII to hexadecimal if the data code in the ID Tag is ASCII.
The result output time can be set to either 100 or 500 ms.
Refer to I/O Settings and Control Methods for details on output timing.
p.69
Trigger Mode can be selected as the method for the communications with the PLC.
The result output time can be set to either 100 or 500 ms.
Refer to I/O Settings and Control Methods for details on output timing.
p.69
Auto Mode can be selected as the method for the communications procedure with the
PLC.
Functions and Operation
Explanation
Explanation
Explanation
Section 3
RFID System
29
User's Manual