Configuration (Dmx); Starting Address; Dmx Personalities - Chauvet Intimidator User Manual

Configuration
(DMX)

Starting Address

DMX
Personalities
Page 10 of 20
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator™ Spot 100 IRC uses up to 11 DMX channels in its 11-channel personality
name/single DMX mode, which defines the highest configurable address to 502.
If unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MODE/ESC> repeatedly until d001—d512 shows on the display.
2. Use <UP> or <DOWN> to select the starting address.
3. Press <ENTER>.
The Intimidator™ Spot 100 IRC has two DMX Channel modes, a 6-channel personality
and an 11-channel personality.
To choose a DMX personality, follow the steps below:
1. Press <MODE/ESC> repeatedly until either 11CH (11-channel mode)
or 6-CH (6-channel mode) shows on the display.
2. Use <UP> or <DOWN> to select the desired DMX personality.
3. Press <ENTER>.
Intimidator™ Spot 100 IRC User Manual