Table of Contents
Advertisement
READ FIRST!
To start using as a Followspot,
press the FUNCTION button until
the Manual LED turns on.
Ask your dealer about
the specially designed
tripod stand with
casters for the TFX-
FS360.
Model Number
CH-W28
USER MANUAL
th
5200 NW 108
Ave Sunrise, FL 33351
(800) 762-1084 – (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
TFX-FS360
Followspot™ 400G
2010-07-20/14:53
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Chauvet TFX-FS360
Summary of Contents for Chauvet TFX-FS360
-
Page 1: User Manual
Ask your dealer about the specially designed tripod stand with casters for the TFX- FS360. Model Number CH-W28 USER MANUAL 5200 NW 108 (800) 762-1084 – (954) 929-1115 Followspot™ 400G Ave Sunrise, FL 33351 FAX (954) 929-5560 www.chauvetlighting.com TFX-FS360 2010-07-20/14:53... -
Page 2: Table Of Contents
DMX P ... 9 RIMER Fixture Linking ... 9 DMX C ... 10 HANNEL ALUES ... 10 OBOS ... 10 AINTENANCE ... 10 ETURNS ROCEDURE ... 11 LAIMS ... 11 ENERAL ROUBLESHOOTING ... 12 ECHNICAL PECIFICATIONS TFX-FS360 User Manual 2010-07-20/14:53... -
Page 3: Before You Begin
Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself. In the unlikely event your unit may require service, please contact CHAUVET®. TFX-FS360 User Manual 1x ENX lamp (360 W, 82 V) ... -
Page 4: Introduction
DMX Channel Summary HANNEL UNCTION Color Dimmer Product Overview Gobo-holder Located and inserted on the bottom side of the followspot. Gobos included Control panel TFX-FS360 User Manual Lamp access Iris Focus Focus handles Control panel Yoke Input/Output Optional CH-W28 Tripod w/casters 2010-07-20/14:53... -
Page 5: Setup
All fixtures must be connected to circuits with a suitable Ground. Gobo Holder The TFX-FS360 can project one gobo image. A gobo- holder is included and is located directly underneath the followspot next to the fan as pictured here on the right. -
Page 6: Mounting
This fixture may be mounted in any safe, position provided there is adequate room for ventilation. ST AT I C M O UNT The TFX-FS360 comes equipped with a yoke for pipe clamp installations. The yoke will provide for a static mount or installation of the followspot for pre-focused use. -
Page 7: Operating Instructions
PERATING NSTRUCTIONS Operating Modes The TFX-FS360 can be operated in the following ways; As a manual followspot using on-board manual controls or slaved to a DMX-512 controller for cue changes. As a static spot controlled by a DMX-512 controller. -
Page 8: Dmx Mode
Appendix Section and read the heading “DMX Primer”. It contains very useful information that will help you understand its use. The TFX-FS360 utilizes two DMX control channels. Press the FUNCTION button until the DMX Mode LED turns on. -
Page 9: Appendix
The chart below details a proper cable conversion: ONDUCTOR ROUND HIELD ( - ) SIGNAL ( + ) SIGNAL TFX-FS360 User Manual COMMON DMX + DMX - IN TO ONVERSION HART 3 Pin Female (output) 5 Pin Male (Input) -
Page 10: Dmx Channel Values
Package must be clearly labeled with a Return Merchandise Authorization Number (RMA #). Products returned without an RMA # will be refused. Call CHAUVET® and request RMA # prior to shipping the fixture. Be prepared to provide the model number, serial number and a brief description of the cause for the return. -
Page 11: Claims
Check polarity switch on controller No flash Re-install bulb, may have shifted in shipping No light output Check slip ring & brushes for contact Install bulb Call service technician TFX-FS360 User Manual Foggers Lights & Snow ... -
Page 12: Technical Specifications
Data pin configuration ... pin 1 shield, pin 2 (-), pin 3 (+) Protocols ... DMX-512 USITT DMX Channels ... 2 ORDERING INFORMATION Followspot™ 400G ... TFX-FS360 Tripod Stand with Casters (optional)... CH-W28 GOBO Outside diameter ... 35.8 mm Image diameter ... 27.9 mm Maximum thickness ...
Need help?
Do you have a question about the TFX-FS360 and is the answer not in the manual?
Questions and answers