Table of Contents
Advertisement
DMX Operation
Master/Slave Mode (Sound-Active, Auto Mode)
4. Operating Instructions
This is the operating mode, which will allow for control using an external DMX controller. You
must set the starting address for this mode.
If this is your first time using DMX, refer to the "DMX Primer" section in the Appendix of this
manual.
1.
Press <MENU> until
2.
Press <ENTER>.
3.
Using <UP> and <DOWN>, select the starting address.
4.
Press <ENTER>.
All fixtures must be individually set to DMX using the instructions above.
This mode allows a single unit to run to the beat of the music, or the unit will change
automatically. DMX cables must be used to daisy chain between the fixtures from the output of
the master unit.
Master:
1.
Set the master unit to run in either Automatic mode or Sound-Active mode. Please
see the appropriate sections on this user manual for instructions on this process.
Slave:
1.
Press <MENU> until
2.
Press <ENTER>.
3.
Using <UP> and <DOWN>, select the starting address of
4.
Press <ENTER>.
All fixtures must be individually set to either master or slave mode using the instructions
above.
Only set one fixture to master. Having two or more master fixtures in the same daisy chain
will prevent the fixtures from working properly.
Do not connect a DMX controller in this setup.
~
appears on the LED screen.
~
appears on the LED screen.
10
.
8/31/2010 4:41 PM
Advertisement
Table of Contents
