Get Your Phone's Ip Address; Install The Firmware - Cisco SPA 504G User Manual

Installing Your Phone
Upgrading Your Phone's Firmware
STEP 1
STEP 2
STEP 3
STEP 1
NOTE
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
NOTE
STEP 7
Cisco Small Business Pro IP Phone SPA 504G User Guide (SIP)

Get Your Phone's IP Address

Before you upgrade, you'll need the IP address of the phone you are upgrading. To get your IP
address:
Press the Setup button.
Scroll to Network and press select.
Scroll to view Current IP. This is the IP address of your phone.

Install the Firmware

Extract the firmware onto your PC.
If you are in a VPN connection, you may need to disconnect before proceeding so that your PC
can communicate directly with your phone for the upgrade.
Run the executable file for the firmware upgrade (for example, double click upg-spa504-6-2-
0.exe).
Click Continue after reading the message regarding upgrading and your service provider.
Enter the IP address of your phone and verify the address of your PC.
Click OK. The system displays information about your phone's current software and
hardware.
Click Upgrade to begin the upgrade.
Do not disconnect your phone's power until the upgrade is complete (the lights on your phone
are no longer blinking).
Click OK to dismiss the status message of the upgrade.
2
22