HP 5400 ZL series Quickspecs page 80

QuickSpecs
Accessory Product Details
HP X132 10G SFP+ LC ER
Transceiver (J9153A)
Services
Ports
Connectivity
Physical characteristics
Environment
Electrical characteristics Power consumption
Cabling
Notes
DA - 12436 North America — Version 34 — December 9, 2014
For supported platforms and minimum software requirements to support this
product, see the document titled "Support for the HP BX Transceivers" on the
"HP Mini-GBICs and SFPs" Manuals Web page.
The J9143B connects to the J9142B "downstream" transceiver, or to any IEEE-
standard 1000BASE-BX10-D ("downstream") device. (A 1000-BX-U
transceiver can only connect to a 1000-BX-D product. You cannot connect two
1000-BX-U transceivers together.)
Power consumption is 1 watt maximum.
Refer to the HP website at www.hp.com/networking/services
the service-level descriptions and product numbers. For details about services
and response times in your area, please contact your local HP sales office.
1 LC 10-GbE port (IEEE 802.3ae Type 10GBASE-ER); Duplex: full only
Connector type
Wavelength
Dimensions
Weight
Transceiver form factor
Operating temperature
Operating relative
humidity
Nonoperating/Storage
temperature
Nonoperating/Storage
relative humidity
Altitude
typical
Power consumption
maximum
Cable type:
Single-mode fiber optic, complying with ITU-T G.652;
Maximum distance:
40km
Fiber type
Check switch release notes for minimum version of software required to
support this transceiver.
Some switches have limits as to how many of this particular transceiver can
be installed. See the release notes of the switch software/firmware being
used for more details.
HP 5400 zl Switch Series
LC
1550 nm
2.22(d) x 0.55(w) x 0.47(h) in. (5.65 x 1.39 x 1.19
cm)
.04 lb., Fully loaded
SFP+
32°F to 158°F (0°C to 70°C)
5% to 95%, noncondensing
-40°F to 185°F (-40°C to 85°C)
5% to 95%, noncondensing
up to 10,000 ft. (3 km)
1.3 W
1.5 W
Single Mode
for details on
Page 80