Star Micronics SCP700 Series Programmer's Manual page 69

2) Paper feed command
In paper mode, the paper feed command and carriage return are
executed in units of dots. A 1/72-inch (0.353-mm) paper feed is
considered 1 dot. Since a 1-dot pitch in the horizontal direction
is 0.30 mm and a 1-dot pitch in the vertical direction is 0.353
mm, the paper amount that is fed while printing using a 90 or
270 rotation is less when compared with a 0 or 150 rotation.
As a result, when printing using a 90 or 270 rotation, execute a
test print, check the horizontal and vertical dot alignment, then
adjust the alignment as necessary.
3) The following commands are not executed in page mode, but
are stored and executed when the printer returns to line mode.
Select 7 9 (half dot) font
Select 5 9 (3 pulses = 1 dot) font
Inverted printing/Cancel inverted
printing
Select highlight printing/Cancel
highlight printing
Underlining
Upperlining
Select print direction
Select emphasized printing/Cancel
emphasized printing
Select left margin
Select right margn
<ESC> "M"
<ESC> ":"
<SI>/<DC2>
<ESC> "4"/<ESC> "5"
<ESC> "-" n
<ESC> "_" n
<ESC> "U" n
<ESC> "E"/<ESC> "F"
<ESC> "1" n
<ESC> "Q" n
67