Star Micronics SCP700 Series Programmer's Manual page 67

CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
Status b7
<ESC> <VT>
(1B)H (0B)H
Set the paper eject direction/length
Sets the length of the ejection operation performed using <ESC>
<FF> 5 in line mode.
The value of m determines the ejection direction.
When m= "+": the ejection direction is into the printer (operational
feed), and the ejection length is n lines (at the current
carriage return)
When m= "-": the ejection direction is backward (backfeed), and
the ejection length is n lines (at the current carriage
return)
When m= 0 : the ejection direction is backward (backfeed), and
the ejection length is n inches
The default value of n is 0.
This command is only valid with the slip printer.
<EOT>
(04)H
Slip status enquiry
Sends slip printer status information to the host computer.
b6 b5 b4 b3
1
Constantly
set at "1"
This command is only valid with the slip printer.
m n
m n
b2 b1 b0
0
Constantly
set at "0"
TOF sensor
BOF sensor
Slip printer mechanical error
Slip release/clamp
1: No paper
1: No paper
1: Error
1: Clamp
0: Release
65