Star Micronics SCP700 Series Programmer's Manual page 42

40
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
<ESC> "h"
1B 68
Set the magnification rate in character height
Prints the subsequent data with a character height magnified by a rate
specified by the value of n.
Receipt printer: n= 0, "0": Reset magnification (same as
Slip printer: n= 0, "0": Reset magnification (same as <DC4>)
1, "1": Double magnification (same as <SO>)
<ESC> "i"
1B 69
Sets the magnification rates in character width and height
Prints the subsequent data in the size specified by n1 and n2. The
value of n1 indicates the height magnification and the value of n2
indicates the width magnification.
Receipt printer: n1 (n2)= 0, "0": Normal height (or width) size
The value of n is between 0(00H) and 5(05H) or "0" (30H) and "5"
(35H). This command is only valid with the receipt printer.
<ESC> "–"
1B 2D
Underlining
When the value of n is 1, underlines the subsequent data including a
character spacing set by <ESC><SP> n.
The part to be skipped by the horizontal tab setting and the block
graphic characters are not underlined.
Resets the underline mode when the value of n is 0.
The value of n can be set to 0(00H) or "0"(30H), or 1(01H) or
"1"(31H).
n
n
<ESC><DC4>)
1, "1": Double magnification (same as
<ESC><SO>)
2, "2": Triple magnification
3, "3": Quadruple magnification
4, "4": Quintuple magnification
5, "5": Sextuple magnification
n1 n2
n 1 n2
1, "1": Double height (or width) size
2, "2": Triple height (or width) size
3, "3": Quadruple height (or width) size
4, "4": Quintuple height (or width) size
5, "5": Sextuple height (or width) size
n
n