ZyXEL Communications ES3500-24 User Manual page 82

Chapter 7 System Status and Port Statistics
Table 12 Status: Port Details (continued)
LABEL
Link
Status
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Tx Packet
The following fields display detailed information about packets transmitted.
Unicast
Multicast
Broadcast
Pause
Rx Packet
The following fields display detailed information about packets received.
Unicast
Multicast
Broadcast
Pause
TX Collision
The following fields display information on collisions while transmitting.
Single
Multiple
Excessive
Late
Error Packet
82
DESCRIPTION
For Ethernet ports, this field displays the speed (10M for 10Mbps or 100M for 100Mbps) and
duplex (F for full duplex or H for half) settings.
For dual-personality interfaces with the RJ-45 port active, this field displays the speed (10M
for 10Mbps, 100M for 100Mbps or 1000M for 1000Mbps), duplex (F for full duplex or H for
half) and media type (Copper) settings.
For dual-personality interfaces with the SFP port active, this field displays the speed (100M
for 100Mbps or 1000M for 1000Mbps), duplex (F for full duplex or H for half) and media
type (Copper or Fiber) settings.
This field displays Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port (see
Section 13.1 on page 124 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
This field shows if LACP is enabled on this port or not.
This field shows the number of transmitted frames on this port
This field shows the number of received frames on this port
This field shows the number of received errors on this port.
This field shows the number kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time the connection has been up.
This field shows the number of good unicast packets transmitted.
This field shows the number of good multicast packets transmitted.
This field shows the number of good broadcast packets transmitted.
This field shows the number of 802.3x Pause packets transmitted.
This field shows the number of good unicast packets received.
This field shows the number of good multicast packets received.
This field shows the number of good broadcast packets received.
This field shows the number of 802.3x Pause packets received.
This is a count of successfully transmitted packets for which transmission is inhibited by
exactly one collision.
This is a count of successfully transmitted packets for which transmission was inhibited by
more than one collision.
This is a count of packets for which transmission failed due to excessive collisions. Excessive
collision is defined as the number of maximum collisions before the retransmission count is
reset.
This is the number of times a late collision is detected, that is, after 512 bits of the packets
have already been transmitted.
The following fields display detailed information about packets received that were in error.
ES3500 Series User's Guide