ZyXEL Communications ES3500-24 User Manual page 326

Chapter 42 Cluster Management
Table 145 Management > Cluster Management > Configuration (continued)
LABEL
VID
Apply
Cancel
Clustering
Candidate
List
Password
Add
Cancel
Refresh
The next summary table shows the information for the clustering members configured.
Index
MacAddr
Name
Model
Remove
Cancel
326
DESCRIPTION
This is the VLAN ID and is only applicable if the Switch is set to 802.1Q VLAN. All
switches must be directly connected and in the same VLAN group to belong to the same
cluster. Switches that are not in the same VLAN group are not visible in the Clustering
Candidates list. This field is ignored if the Clustering Manager is using Port-based
VLAN.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
The following fields relate to the switches that are potential cluster members.
A list of suitable candidates found by auto-discovery is shown here. The switches must
be directly connected. Directly connected switches that are set to be cluster managers
will not be visible in the Clustering Candidate list. Switches that are not in the same
management VLAN group will not be visible in the Clustering Candidate list.
Each cluster member's password is its web configurator password. Select a member in
the Clustering Candidate list and then enter its web configurator password. If that
switch administrator changes the web configurator password afterwards, then it cannot
be managed from the Cluster Manager. Its Status is displayed as Error in the
Cluster Management Status screen and a warning icon (
summary list below.
If multiple devices have the same password then hold [SHIFT] and click those switches
to select them. Then enter their common web configurator password.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Click Refresh to perform auto-discovery again to list potential cluster members.
This is the index number of a cluster member switch.
This is the cluster member switch's hardware MAC address.
This is the cluster member switch's System Name.
This is the cluster member switch's model name.
Select this checkbox and then click the Remove button to remove a cluster member
switch from the cluster.
Click Cancel to begin configuring this screen afresh.
) appears in the member
ES3500 Series User's Guide