ZyXEL Communications ES3500-24 User Manual page 153

Table 47 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Criteria
Port
Group
Apply
Cancel
ES3500 Series User's Guide
DESCRIPTION
Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the src-
dst-mac distribution type. If the Switch is behind a router, the packet's destination or source
MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP
address to make sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
This field displays the port number.
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 17 Link Aggregation
153