ZyXEL Communications ES3500-24 User Manual page 197

Note: Your Switch automatically creates a static VLAN (with the same VID) when you
create a multicast VLAN in this screen.
Figure 104 Advanced Application > Multicast > Multicast Setting > MVR
The following table describes the related labels in this screen.
Table 70 Advanced Application > Multicast > Multicast Setting > MVR
LABEL
Active
Name
Multicast VLAN
ID
802.1p Priority
Mode
Port
*
ES3500 Series User's Guide
DESCRIPTION
Select this check box to enable MVR to allow one single multicast VLAN to be shared
among different subscriber VLANs on the network.
Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
Enter the VLAN ID (1 to 4094) of the multicast VLAN.
Select a priority level (0-7) with which the Switch replaces the priority in outgoing IGMP
control packets (belonging to this multicast VLAN).
Specify the MVR mode on the Switch. Choices are Dynamic and Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the multicast VLAN.
Select Compatible to set the Switch not to send IGMP reports.
This field displays the port number on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Chapter 24 Multicast
197