ZyXEL Communications ES3500-24 User Manual page 174

Chapter 21 Policy Rule
Table 57 Advanced Application > Policy Rule (continued)
LABEL
General
Egress Port
Priority
DSCP
TOS
Rate Limit
Bandwidth
Action
Specify the action(s) the Switch takes on the associated classified traffic flow.
Forwarding
Priority
Diffserv
Outgoing
Rate Limit
Add
Cancel
Clear
174
DESCRIPTION
Type the number of an outgoing port.
Specify a priority level.
Specify a DSCP (DiffServ Code Point) number between 0 and 63.
Specify the type of service (TOS) priority level.
You can configure the desired bandwidth available to a traffic flow.
Specify the bandwidth in kilobit per second (Kbps). Enter a number between 1 and 1000000.
Select No change to forward the packets.
Select Discard the packet to drop the packets.
Select Do not drop the matching frame previously marked for dropping to retain the
frames that were marked to be dropped before.
Select No change to keep the priority setting of the frames.
Select Set the packet's 802.1p priority and send the packet to priority queue to
replace the packet's 802.1p priority field with the value you set in the Priority field. Then put
the packets in the designated queue.
Select Replace the 802.1p priority field with the IP TOS value and send the packet
to priority queue to replace the packet's 802.1p priority field with the value you set in the
TOS field. Then put the packets in the designated queue.
Select No change to keep the TOS and/or DSCP fields in the packets.
Select Set the packet's TOS field to set the TOS field with the value you configure in the
TOS field.
Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the value
you configure in the DSCP field.
Select Send the packet to the egress port to send the packet to the egress port.
Select Enable to activate bandwidth limitation on the traffic flow(s).
Click Add to insert the entry in the summary table below and save your changes to the
Switch's run-time memory. The Switch loses these changes if it is turned off or loses power,
so use the Save link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
ES3500 Series User's Guide