ZyXEL Communications ES3500-24 User Manual page 235

Chapter 27 Loop Guard
The following figure shows port N on switch A connected to switch B. Switch B is in loop state.
When broadcast or multicast packets leave port N and reach switch B, they are sent back to port N
on A as they are rebroadcast from B.
Figure 130 Switch in Loop State
B
A
N
The loop guard feature checks to see if a loop guard enabled port is connected to a switch in loop
state. This is accomplished by periodically sending a probe packet and seeing if the packet returns
on the same port. If this is the case, the Switch will shut down the port connected to the switch in
loop state.
The following figure shows a loop guard enabled port N on switch A sending a probe packet P to
switch B. Since switch B is in loop state, the probe packet P returns to port N on A. The Switch
then shuts down port N to ensure that the rest of the network is not affected by the switch in loop
state.
Figure 131 Loop Guard - Probe Packet
B
A
P
P
N
The Switch also shuts down port N if the probe packet returns to switch A on any other port. In
other words loop guard also protects against standard network loops. The following figure
illustrates three switches forming a loop. A sample path of the loop guard probe packet is also
shown. In this example, the probe packet is sent from port N and returns on another port. As long
as loop guard is enabled on port N. The Switch will shut down port N if it detects that the probe
packet has returned to the Switch.
Figure 132 Loop Guard - Network Loop
A
N
P
235
ES3500 Series User's Guide