Bios Configuration; Create Raid In Bios - Foxconn Inferno Katana User Manual

English manual.
Table of Contents

Advertisement

5-2 BIOS Configuration

1. Enter the BIOS setup by pressing <DEL> key during the POST(Power On Self Test).
2. Select the "Advanced BIOS
Configuration" item and press <Enter> to go to the configuration items.
3. Select and Set the "Configure SATA as" option to [RAID].
4. Press <F10> to save the setting then PC will reboot itself.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
IDE Configuration
Configure SATA as
SATA#1 IDE Configuration
SATA#2 IDE Configuration
► Primary IDE Master
► Primary IDE Slave
► Secondary IDE Master
► Secondary IDE Slave
► Third IDE Master
► Fourth IDE Master
Hard Disk Write Protect
IDE Detect Time Out
ATA(PI) 80Pin Cable Detect
↑↓←→:Move Enter:Select

5-3 Create RAID in bIoS

enter RAID bIoS Setup
When BIOS is restarted, it will display a message asking you to press <Ctrl>+<I> keys
simultaneously to enter the main menu of Intel
Utility. Press the <Ctrl>+<I> to enter Configuration Utility.
Intel(R) Matrix Storage Manager option ROM v5.0.0.1011 ICH9R wRAID5
1. Create RAID Volume
2. Delete RAID Volume
RAID Volume :
None Defined.
Physical Disks:
Port Drive Model
0
Maxtor STM332082
2
WDC WD1500ADFD-0 WD-WMAP42036047
3
WDC WD800AAJS-00 WD-WMAP95242993
4
WDC WD3200AAKS-0 WD-WCARW4154961
Features" from the "Main menu",
IDE Configuration
RAID
Compatible
Enhanced
Not Detected
Not Detected
Not Detected
Not Detected
Not Detected
Not Detected
Disabled
35
Host & Device
+/-/:Value F10:Save ESC:Exit
Intel(R) Matrix Storage Manager option ROM v8.9.0.1023 PCH-D wRAID5
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
Copyright(C) 2003-04 Intel Corporation All Rights Reserved.
1. Create RAID Volume
[
DISK/VOLUME INFORMATION
Serial #
6QF4CRAW
[↑↓]-Select
IDE
RAID
AHCI
Disabled
F9:Optimized Defaults
Matrix Storage Manager Option ROM
®
[
MAIN MENU
]
3. Reset Disks to Non-RAID
4. Recovery Volume Options
5. Exit
]
Size
298.0GB
139.7GB
74.5GB
298.0GB
[ESC]-Exit
[ENTER]-Select Menu
78
then select the "IDE
Help Item
Options
F1:General Help
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
Non-RAID Disk
Non-RAID Disk

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents