Advanced Bios Features - Foxconn Inferno Katana User Manual

Advanced BIOS Features

CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Advanced Settings
► IDE configuration
► AHCI Configuration
► MPS Configuration
↑↓←→:Move Enter:Select
► IDE Configuration/ACHI Configuration/MPS Configuration
Press <Enter> to go to relative submenu.
IDE Configuration
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
IDE Configuration
Configure SATA as
SATA#1 IDE Configuration
SATA#2 IDE Configuration
► Primary IDE Master
► Primary IDE Slave
► Secondary IDE Master
► Secondary IDE Slave
► Third IDE Master
► Fourth IDE Master
Hard Disk Write Protect
IDE Detect Time Out
ATA(PI) 80Pin Cable Detect
↑↓←→:Move Enter:Select
► Configure SATA as
This item is used to set the operation mode of your SATA ports 1, 2, 3, 4, 5, 6. Setting values
are: [IDE]; [RAID]; [AHCI]; [Disabled].
[IDE] - This configures the SATA ports to support IDE mode.
[RAID] - When you enable RAID, it means all your SATA drives must also support AHCI.
[AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register
level interface for a Host Controller for Serial ATA. The specification includes a description of
the hardware/software interface between system software and the host controller hardware.
Advanced BIOS Features
Press Enter
Press Enter
Press Enter
Press Enter
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
IDE Configuration
IDE
IDE
Compatible
Enhanced
Not Detected
Not Detected
Not Detected
Not Detected
Not Detected
Not Detected
Disabled
35
Host & Device
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
31
Help Item
Configure the IDE
device(s).
F1:General Help
Help Item
Options
IDE
RAID
AHCI
Disabled
F1:General Help