Mes. Settings; Changing The Mes. Settings - Epson SF-710 User Manual

SF-710/510/310 User's Guide

Mes. Settings

Allows you to change the measurement settings.

Changing the Mes. Settings

c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
"Specifying a GPS (GPS Positioning)" on
U
page 28
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes or Failed is
displayed, we recommend selecting Cancel,
moving to a different location, and trying
again.
Operation buttons
A
Display the measurement screen.
Use one of the following methods to display.
❏ When performing GPS positioning:
Press C on the time screen.
❏ When skipping GPS positioning:
Press C on the time screen, and then select
Skip on the GPS positioning screen.
"Skipping GPS positioning" on
U
page 29
❏ When not performing GPS positioning
(Indoor mode: SF-710/SF-510 only):
Hold down C on the time screen.
Settings
"Indoor mode (SF-710/SF-510 only)"
U
on page 30
B
Display the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select a setting item.
Use C/D to select, and then press A.
D
Select a setting value.
Use C/D to select, and then press A.
Depending on the setting item, you may need to
make further settings. Follow the on-screen
instructions.
Note:
When setting a number, hold down C/D to speed
through the numbers.
E
Complete the settings.
Hold down A.
87