Recording Laps Automatically (At Lap Function) - Epson SF-710 User Manual

SF-710/510/310 User's Guide
Recording Laps
Automatically (AT Lap
Function)
When a time or distance set in advance is reached, laps
are recorded automatically.
Set the lap time or distance. You can set five times or
distances. However, only one setting can be used while
measuring.
c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
"Specifying a GPS (GPS Positioning)" on
U
page 28
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes or Failed is
displayed, we recommend selecting Cancel,
moving to a different location, and trying
again.
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
Measure
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
"Skipping GPS positioning" on page 29
U
❏ Use indoor mode when GPS positioning
cannot be performed because you are indoors
and so on.
"Indoor mode (SF-710/SF-510 only)" on
U
page 30
B
Displays the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select AT Lap.
Use C/D to select, and then press A.
D
Select one of the settings from 1 to 5.
Use C/D to select, and then press A.
55