Changing The Measurement Screen - Epson SF-710 User Manual

SF-710/510/310 User's Guide
Changing the Measurement
Screen
The setting method varies depending on the screen
pattern. See the explanations for each screen pattern.
"Setting 1 Line/2 Lines/3 Lines" on page 101
U
"Setting Pace&Graph/HR&Graph" on page 102
U
"Setting Lap/Target Pace/OFF" on page 104
U
c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
"Specifying a GPS (GPS Positioning)" on
U
page 28
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes or Failed is
displayed, we recommend selecting Cancel,
moving to a different location, and trying
again.
Setting 1 Line/2 Lines/3 Lines
Here we will explain how to display Calories Burnt in
Screen4 using 1 Line.
Operation buttons
A
Display the measurement screen.
Use one of the following methods to display.
❏ When performing GPS positioning:
Press C on the time screen.
❏ When skipping GPS positioning:
Press C on the time screen, and then select
Skip on the GPS positioning screen.
"Skipping GPS positioning" on
U
page 29
Settings
❏ When not performing GPS positioning
(Indoor mode: SF-710/SF-510 only):
Hold down C on the time screen.
"Indoor mode (SF-710/SF-510 only)"
U
on page 30
B
Display the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select Screen.
Use C/D to select, and then press A.
D
Select Screen4.
Use C/D to select, and then press A.
101