Foxconn Destroyer User Manual page 41

USB Devices
USB 1.1 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Support
USB Mouse Support
USB Storage Support
***USB Mass Storage Device Boot Settinf***
↑↓→←:Move Enter:Select
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the [High Speed], then the USB
operation mode is determined by the USB device; select [Full/Low Speed], the USB device
operates on full/low speed.
► USB Keyboard Support
This item is used to enable the support for USB keyboard on legacy OS. If you have a USB
keyboard, set to enabled.
► USB Mouse Support
This item is used to enable the support for USB mouse on legacy OS. If you have a USB
mouse, set to enabled.
► USB Storage Support
This option is used to set whether the USB Mass Storage controller is enabled in a legacy
operating system (such as DOS).
***USB Mass Storage Device Boot Setting***
BIOS auto detects the presence of USB Mass Storage Devices, you can configure the Boot
setting mode for the detected USB MSD. Setting Options: [Auto]; [FDD Mode]; [HDD Mode].
Phoenix - AwardBIOS CMOS Setup Utility
USB Devices
[ Enabled
[Enabled]
[High Speed]
[Enabled]
[Enabled]
[Enabled]
+/-/PU/PD:Value F10:Save
F5:Previous Values
34
] Item Help
Menu Level ►
[Enable] or [Disable]
Open Host Controller
Interface for Universal
Serial Bus.
ESC:Exit F1:General Help
F7:Optimized Defaults