Foxconn Destroyer User Manual page 40

► OnBoard BCM5788 / BCM5786 Controller
This item is used to enable or disable the onboard LAN controller.
► OnBoard 1394 Controller
This item is used to enable or disable the onboard 1394 controller.
► BCM5788 / BCM5786 LAN Boot ROM
This item is used to enable or disable the onboard LAN boot optional ROM. A LAN boot ROM
lets you set up a diskless workstation on the network. By installing a boot ROM in the network
board, you can enable a client PC system on the network to be booted remotely.
SuperIO Devices
OnBoard FDC Controller
OnBoard Serial Port 1
OnBoard IrDA Port
IrDA Mode Select
IrDA Duplex Mode
↑↓→←:Move Enter:Select
► OnBoard FDC Controller
This item is used to enable or disable the onboard FDC controller.
► OnBoard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port COM1.
► OnBoard IrDA Port
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard IrDA
port.
► IrDA Mode Select
This item is used to configure IrDA port mode:
[IrDA]: An IrDA device for maximum baud rate of 115200 bit/s.
[ASKIR]: A faster IrDA for 1152000 bit/s.
► IrDA Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip.
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Devices
[Enabled]
Enabled
[3F8/IRQ4]
[2F8/IRQ3]
[IrDA]
[Half]
+/-/PU/PD:Value
F5: Previous Values
33
Item Help
Menu Level ►
F10:Save ESC:Exit F1:General Help
F7: Optimized Defaults