Using The Ir Remote Control; Figure 1-4 Ir Remote Control - Honeywell Performance HRG4 User Manual

Using the IR Remote Control

Your HRG DVR may also be controlled with the IR remote control. Batteries (2 x AAA) must be
installed before operation.
Configuring the IR Remote Control
Aim the remote control at the IR receiver located at the front of the unit to test operation. If there
is no response, try the following steps:
1.
2.
3.
4.
5.
The Status indicator on the front panel should turn green to indicate that the remote control is
operating properly.
Figure 1-4 IR Remote Control
Table 1-2
# Button
1 POWER
2 DEV
3 Alphanumerics
4 EDIT
5 A
6 REC
7 PLAY
8 INFO
9 VOIP
10 MENU
11 PREV
12 DIRECTION/ENTER
13 PTZ
14 ESC
15 RESERVED
16 F1
17 PTZ CONTROL Buttons
18 F2
See HRG4 Front Panel on page 17
page 18
Use the front control panel or the mouse to navigate to Menu
More Settings.
Check and remember the HRG DVR ID number. The default ID number is 255. This ID
number is valid for all IR remote controls.
Press DEV on the remote.
Enter the DVR ID number from step 2.
Press ENTER on the IR remote control.
IR Remote Control
for more about front panel controls.
Introduction | 19
Function
Turn On/Off the HRG DVR.
Enable/Disable Remote Control
Same as front panel
Same as JKL/EDIT on front panel.
Same as 0/A on front panel.
Same as 7/PQRS/REC on front panel.
Same as 6/MNO/PLAY on front panel.
Reserved.
Same as 2/ABC/F1 on front panel.
Same as 1/MENU on front panel.
Same as 9/WXYZ/PREV on front panel.
Same as on front panel.
Same as 8/TUV/PTZ on front panel.
Same as ESC on front panel.
Reserved.
Same as 2/ABC on front panel.
Use to adjust the iris, focus, and zoom.
The F2 button is used to cycle through tab
pages. It can also be used to enter the
Channel and OSD Position settings.
and HRG8 and HRG16 Front Panel on
 
Settings
800-12005 - A - 06/2012

General