Configuring Remote Alarm Host Settings; Figure 8-7 Ntp Settings Menu - Honeywell Performance HRG4 User Manual

To set up an NTP server:
1.
2.
3.
4.
5.
6.

Configuring Remote Alarm Host Settings

With a remote alarm host set, the HRG DVR will send a signal to the host when an alarm is
triggered. The remote alarm host must have the Network Video Surveillance software installed.
To set up a remote alarm host:
1.
2.
3.
 
Click Menu Settings
Select the Advanced tab.
Next to NTP, click Set to enter the NTP Settings menu (see
Figure 8-7 NTP Settings Menu
Select the NTP check box to enable this feature.
Configure the NTP settings:
• Synchronize Interval: Time in minutes to synchronize with the NTP server.
• NTP Server: Address of the NTP server.
Note The address can be set to the IP address or the domain name. When the domain
name is used, please set the DNS server address.
Click OK to save the settings and exit the menu.
Note Time synchronization interval has a range of 0 to 10080 min, normally 7200 min. If
the DVR is used on a public network, you should use an NTP server that has a
time synchronization function, such as the server at the National Time Center (IP
Address: 210.72.145.44). If the DVR is set up in a more customized network, NTP
software can be used to establish an NTP server used for time synchronization.
 
Click Menu Settings
Select the Advanced tab.
Next to Host/Others, click Set to enter the Host/Others menu (see
Network to enter the Network Settings menu.
Network to enter the Network Settings menu.
Network Settings | 77
Figure 8-7).
Figure 8-8).
800-12005 - A - 06/2012