A Typical 828Mk3 Setup - MOTU 828 Mk III Hybrid User Manual

A TYPICAL 828MK3 SETUP

Here is a typical 828mk3 studio setup. This rig can
be operated without an external mixer. All mixing
and processing can be done in the computer with
audio software. During recording, you can use the
828mk3's CueMix FX no-latency monitoring to
listen to what you are recording via the main outs,
MOTU 8pre and/or
other optical devices
828mk3
back panel
S/PDIF
DAT deck
26
guitar
828mk3
front panel
8-channel
ADAT optical
MIDI IN/OUT
FireWire or USB
PC
Figure 4-12: A typical 828mk3 studio setup.
headphone outs, or any other output pair. You can
control monitoring either from the front panel or
from the included CueMix FX software. The two
front-panel guitar/mic inputs can be routed to
outboard effects processors, such as a compressor,
EQ or reverb, via the rear panel sends.
headphones
mic
foot
switch
sends to other outputs (stage
FX unit monitors, surround
(in rack monitors, etc.)
below)
send
returns
quarter-inch
analog outs
synthesizer
I N S T A L L I N G T H E 8 2 8 M K 3 H A R D W A R E
headphones
monitors
to send returns
Compressor, reverb or
other outboard gear
quarter-inch analog outs
synths, samplers, effects units, etc.