Table of Contents
Advertisement
Note
If the cover does not slide all the way to the front of the chassis, check that the cover
tabs at the front of the cover are properly inserted into their slots in the chassis. Also check that
the locking tab is inserted into its slot on the back edge of the chassis.
Replace the two previously removed thumbscrews.
5.
If you have a padlock for the locking tab on the rear edge of the chassis, install it.
6.
Reconnect all external peripherals.
7.
Plug in the power cables.
8.
Front Panel
The following sections describe how to remove and replace the front panel. Remove the front
panel to access the system's accessible devices.
Removing the Front Panel
Remove the front panel as follows.
Remove the cover (see "Removing the Cover" earlier in this section).
1.
Position the system on its side on the work table, with the front panel over the edge of the
2.
table.
From inside the chassis, press up on the two front panel locking tabs to release them from
3.
their slots on the edge of the chassis (see the following figure for tab location).
On the right side of the front panel, at the top corner, press in on the panel to release the top.
4.
Pull out the top of the front panel while pulling up on the panel to release it from the
5.
chassis.
Set the front panel aside.
6.
Replacing the Front Panel
Replace the front panel as follows.
Align the three tabs on the inside edge of the front panel with their corresponding slots on
1.
the lower edge of the chassis (see the following figure).
3-6 Disassembly and Reassembly
Removing the Front Panel
A – Chassis Slots
B – Locking Tabs
Advertisement
Table of Contents
