Pop Up Menus - Viking Designer I User Manual

Learn your Designer I
Pop-up menus
Top Thread Break
Your Designer I stops automatically if the top th-
read runs out or breaks. Rethread the top thread,
touch .
Empty Bobbin
Your Designer I stops automatically when the
bobbin thread is almost empty. Replace the emp-
ty bobbin with a full one, touch .
Note: It is possible to continue sewing un til all
thread on the bobbin has run out.
Twin needle
When the twin needle safety button is set in
the menu, the width of the stitches is
limited. If you select a stitch that is too wide the
twin needle pop-up appears. The stitch width of
the selected stitch is adjusted automatically to fi t
the twin needle setting.
The twin needle pop-up also appears if the twin
needle safety button is set when the machine is
turned on.
Touch the -tab and touch the single needle
button to cancel the twin needle safety.
Sensor foot Q
Sensor Q-foot (optional) is set to in the
menu. Change to to cancel.
Stitch Width Safety
If you have been using a straight stitch plate (op-
tional) or the P-foot and have set the stitch width
safety, the Designer I alerts you when turning on
the machine or when selecting a stitch that has
stitch width more than 0.0.
33