Connecting The Embroidery Unit - Viking Designer I User Manual

Embroidery
Creative Embroidery from
Husqvarna Viking
Down through the ages, people all over the world
have enjoyed stitching embroidery designs to
personalize and embellish clothing, table linens
and special heirlooms. Early embroideries were
stitched by hand. Today your Husqvarna Viking
Designer I embroiders your design effortlessly.
Embroidery unit
1. Embroidery unit socket
2. Embroidery arm
3. Embroidery hoop attachment
4. Embroidery unit release button
Embroidery Unit Carrying Case
The carrying case contains embroidery unit,
2 embroidery hoops; standard and large, em-
broidery Presser foot R, embroidery booklet,
2 embroidery templates; standard and large, a
template pencil, Sampler 100 embroidery disks:
1 disk of designs and 3 font disks, a pair of scis-
sors, two thread nets, 1 felt holder and a test kit.
Store your embroidery accessories in the carry-
ing case to prevent misplacing them.

Connecting the Embroidery unit

1. Slide off the accessory tray.
2. There is a covered socket at the back of the
machine. Turn the cover to the right to open
it. The embroidery unit plugs into this socket.
3. Slide the embroidery unit on the free arm
of the machine until it plugs fi rmly into the
socket. Switch on the machine.
4. A Pop-up menu tells you to clear the area
and remove the hoop for calibration. Touch
. The machine will calibrate and the em-
broi dery arm will move to the ready po si tion.
Calibration will set your em broi dery func tions
each time you sli de on the em broi dery unit.
5. The feed teeth are lo we red automatically
when the embroidery unit is connected and
are raised when it is removed.
64
Embroidery
Presser foot R
2.
3.
4.
1.