Viking Designer I User Manual page 31

Calibration of the Color Touch Screen
If you touch a function tab or stitch picture on
the Color Touch Screen but it does not respond
or the function next to it is activated instead, the
screen has to be calibrated. The Color Touch
Screen is calibrated at the Husqvarna Viking fac-
tory, but the settings may be affected when the
machine is shipped and transported. You only
need to calibrate the Color Touch Screen if there
is a precision problem when touching the func-
tion tabs or stitch pictures.
To calibrate the Color Touch Screen, touch
then touch twice. Select "Color Touch Screen
adjust" in the third menu and the calibration
screen appears.
1. Touch in the center of cross 1 (the up per left
corner of the screen). This is best done with a
pointed but not sharp object (for in stan ce the
blunt plug end of the Sensor Buttonhole foot).
When the cross changes from black to green
the fi rst point is set.
2. Touch in the center of cross 2 (lower right
corner of the screen) to set the second point.
Touch Save to store the new setting.
The calibration is now completed.
You can always use
screen without saving any changes.
Note: When calibrating the screen, be sure to touch
the cross areas only, as recommended. If other areas
are touched, the screen can be miscalibrated. A mis-
ca li bra ted screen may require an adjustment by an
authorized technician.
Touch to close the
Fix
Touch if you want to decide when to use
"FIX". automatically activates Fix at stitch se-
lection and after thread cut.
Sensor Q-foot
Touch to set the Sensor System to operate
the optional Sensor Q-foot.
Grid
The 20x20 mm grid function is very useful when
you are going to customize several designs to-
gether (see Customizing designs). Align your
designs by using the grids. Touch
the grid function.
Learn your Designer I
to leave the Calibration
menu.
to activate
,
31