Zipper - Viking Designer I User Manual

Center zipper
Fabric: Woven medium
Touch: Woven medium on the Sewing Advisor
Use: Size 80 needle.
Touch: Seam on the Sewing Advisor and sew
the two fabrics together along the 5/8'' (15mm)
seam line up to the notch at the zipper pla ce -
ment.
Touch: Baste on the Sewing Advisor and baste
the zipper area of the seam together. Press the
seam open. Pla ce the zipper right side to the
pres sed open seam allowance. Close the Sewing
Advisor.
Touch: Menu V. To bar tack baste zipper in
pla ce, touch Zigzag stitch V2. Lower the feed
teeth by turning the dial to
bric to stitch a series of bar tacks over the zipper
to hold it in place. Turn the feed teeth dial to
sewing position
Touch: Menu A, A1 for left needle position
straight stitch.
Snap on: Zipper foot E. Snap it on so the need-
le is on the left side of the foot. There are two
bars on the foot so you can snap on the foot to
the right or left of the needle. Place fabric under
the foot right side up with the zipper foot to on
the right side of the zipper.
If you need to adjust fabric, touch Pivot
Sew:
• Step on the foot control. The Sensor Foot lo-
wers automatically.
• Begin stitching across the bottom, turn and
stitch the right side of the zipper to the top.
• To avoid fabric shifting, sew the left side of
the zipper in the same direction, touch A3
for right needle position straight stitch. Snap
on zipper foot E so the needle is on the right
side of the foot.
• Begin stitching across the bottom, turn and
stitch the left side of the zipper sewing from
the bottom to the top.
• Remove bartacks and basting stitch.
Note: To adjust the position of the stitching line,
adjust the needle position. Touch
stitch width to move the needle towards the
cen ter position.
56
Utility/Garment Sewing
. Move the fa-
.
, Touch
.