Pop-Up Menus In Embroidery - Viking Designer I User Manual

Embroidery

Pop-up menus in Embroidery

Embroidery Start Up Calibration
As the embroidery unit is connected to the mach-
ine, a Pop-up menu prompts you to slide off the
hoop, and clear the machine area for positioning
of the embroidery arm. Touch OK to calibrate
the embroidery unit and to position the arm.
This menu also reminds you to use the R foot.
Top Thread Break
Your Designer I stops automatically if the top th-
read runs out or breaks. Rethread the top thread,
touch OK. Touch to continue.
Empty Bobbin
Your Designer I stops when the bobbin is almost
empty. Replace the empty bobbin with a full
one, touch OK (bobbin winding, see page 10).
Note: When changing the bobbin, touch and the
hoop will move away for easy access to the bobbin
case. Once the bobbin is replaced, touch again to
move the hoop back to where em broi dery stopped.
Touch to resume the embroidery.
Color Change
Your Designer I stops automatically and the top
thread only is cut at the color change. Remove
the spool and rethread the top with the recom-
mended color shown in the color menu of the
color touch screen or in the Embroidery Booklet.
Touch OK and to resume embroidering.
Cut Embroidery Top Thread Tail
Your Designer I stops automatically a few stit-
ches after you begin embroidering. Cut the
star ting thread tail, touch OK and to resume
embroidering.
Wrong hoop for embroidery
When the size of the hoop on the machine does
not match the size displayed on the screen, your
Designer I will not sew. Change the hoop to the
size displayed on the screen.
Stop requested in design
Designer I stops when you are supposed to do a
cut work, applique etc. See explanation for each
design in the Embroidery Booklet.
Embroidery fi nished
When your embroidery is complete a pop-up
menu will appear. Touch OK to get back to your
embroidery.
74