Embroidery Template - Viking Designer I User Manual

Embroidery Template

Because the embroidery designs are pictured
actual size in the Embroidery Booklet it is easy
to place the embroidery on your garment or
project. Use the embroidery template size that
corresponds with hoop size.
1. Place the template over the picture of the
selected design in the Embroidery Booklet.
2. Use the template pencil to trace the outline of
the design onto the template.
3. Place the template on the project to be em-
broidered and mark the center point, side,
and top and bottom markings through the
holes in the template. Use the Pictogram Pen.
4. Open the screw on the outer hoop. Place it
on a fi rm surface. Put the stabilizer and the
project to be embroidered on top of the outer
hoop and set the inner hoop on top mat-
ching the side, top and bottom markings on
the hoops with the Pictogram Pen markings
on the project. Take the time to be sure the
marks are all aligned.
5. Push the inner hoop into the outer hoop and
tighten the screw.
Slide the hoop onto the machine.
The marked center point should match the star-
ting point of the needle. If minor adjustment is
needed, touch the positioning buttons on the
embroidery screen submenu.
Note: Read more about Stabilizer and Hoops in the
Accessory User's Guide.
Embroidery
67